Special filters for the treatment of iron and manganese in water by means of specific filter beds.

All filters for iron and manganese removal are prepared for easy operation and minimum maintenance.

These filtration models are used for high capacity industrial and urban applications, reaching daily flow rates of up to 31 m3/h.

Technical characteristics of iron and manganese filters IMA water

• Power supply 220V-12V.
• Connections:
  • 4 inches Filters diameter 780mm.
  • 6 inches filters diameter 1088,1250,1600mm.
• Maximum working pressure 150 psi.
• Working temperature 0ºC to 35ºC.
• Katalox filter: Recommended PH 6-9.
• If Fe+Mn concentration is higher than 0.5 ppm. Additional oxidation treatment may be necessary.
• Body made of fiberglass reinforced polyester.
• Automatic diaphragm valve, mounted on the front of the column. Water cut-off during washing.
• Controller programmed for washing cycles.
• Inner distributors suitable for the design flow rate.
• Complete with KATALOX filtering load.

Included equipment:

• Valve front with inlet/outlet control gauges.
• KATALOX filter bed.
• Discharge mouth for replacement of 4-inch filtering bed in 1088, 1250 and 1600 diameter filters.
• Upper and lower strainer kit.

Contact us without obligation by phone or email for any technical advice or purchase of our equipment.